Most homeowners would be shocked if they could look inside their ductwork!
Even the most careful housekeeper cannot prevent a gradual accumulation of dust,
dirt, hair, dead insects (or worse) on the inside surfaces of the air ducts in the
heating and air conditioning system. In addition, ductwork can become a breeding
ground for various molds, mildew, germs, and bacteria that can be a real problem for
those with asthma or severe allergies.
The solution is to contact Mite-E-Ducts today. Our
technicians are certified by NADCA, the National Air Duct Cleaners Association.
They will use state-of-the-art equipment and cleaning tools to thoroughly clean
all the interior surfaces of your ductwork, along with the fan and blower
compartment of furnaces that permit access to those areas.
BUYER
BEWARE! $49.95 for
a whole house duct cleaning? If it sounds too good to be true; it probably is!
Click Here to see why.
We can:
Clean your heating and air conditioning ductwork
Sanitize
the ductwork to help kill mold, mildew and bacteria
Deodorize the ductwork to help with animal, moisture and smoke odors
*The Service Operator will be happy to explain each cleaning procedure to
you.
1. The Service operator will lay down runners on finished floors
and place corner guards on each corner we turn around.
2. The Operator will gain access for the vacuum hose by making
an 8" or 10" opening into the main trunklines of both the
supply and return side of the system.
FAQ: Do you cut into my furnace?
Answer: Although we clean the furnace our air handler,
we do NOT cut into the actual furnace or air handler, just the duct
system. Thus, we will not damage it.
3. The vacuum hose will be inserted into this opening to prepare
for the HiVAC unit to be started which will produce a vacuum
throughout the system.
FAQ: How Do you hook up to slab?
Answer: With our custom slab box.
4. The filter will be tightly covered so that we can
separate both sides of the system. Also this will ensure that no
debris is being pulled through your indoor A/C Coil.
Some supply and return vents may have to be covered or
have the dampers closed so that
the full vacuum will be drawing through each vent, and the whole
system will be under a negative pressure. The technician will clean
the vents one at a time.
5. A compressed air nozzle and special pneumatic tools will be
inserted into each supply and return vent; the compressed air and
air whips will
blow the dirt and debris toward the drawing vacuum hose and
delivering it to our truck mounted holding compartment.
6. Our Viper cleaning system will be inserted in to the
main trunk lines and plenums after all vents have been cleaned out.
It will be propelled throughout the system loosening remaining dirt
and debris and blowing it into the vacuum system.
FAQ: Do you use brushes?
Answer: If the situation or job calls for brushes,
then yes. The problem with brushes is, they are round; therefore
they cannot get into the corners of square and rectangular ductwork
like our Viper Air Whip system can.
7. After thoroughly cleaning both sides of the duct
system. We will continue to clean out the furnace, blower
compartment and filter area.
8. All openings are sealed with inspection plates that are
screwed on to the ductwork. The inspections plates will not leak air.
They have a folded lip on the inside that is also lined with foam
tape, this will ensure no air leakage. These plates will be used in
future cleaning and inspections.
Mite-E-Ducts is a Residential and Commercial air duct cleaning company located
in Zionsville, Indiana. We serve a
statewide customer base
including customers in Brownsburg, Carmel, Fishers, Greenwood, Noblesville, Zionsville, and the greater Indianapolis
area.
Air duct cleaning is all we do!
*NOTE: Mite-E-Ducts is NOT a franchise, and we DO NOT USE SUB-CONTRACTORS.
Mite-E-Ducts is a member of the Duct Cleaners' Network, Angie's List, &
N.A.D.C.A.
MITE-E-DUCTS IS LICENSED, BONDED, & INSURED
Phone: (317) 733-1012
Toll Free: 1-877-866-3478
MITE-E-DUCTS
1200 Parkway Dr.
Zionsville, IN 46077
AirDuct.info